Fantasea Line FRX100 VA R Instruction Manual page 25

Identification of System Parts
* With a Vacuum Valve installed on the housing's dedicated M16 port * With a Vacuum Valve installed on the housing's dedicated M16 port
Vacuum Valve
Protective Cap
Charging the Unit
1. Turn the unit on using the power switch featured on the Signal Board. Turn the unit on using the power switch featured on the Signal Board.
2. The LED Indicator will start flashing blue: The LED Indicator will start flashing blue:
a. Slow flashing (approx. 1 flash per second) indicates a Slow flashing (approx. 1 flash per second) indicates a
charged battery.
b. Rapid flashing (approx. 4 flashes per second) indicates low flashing (approx. 4 flashes per second) indicates low
battery.
3. To charge the unit, connect it to a USB charger using a standard To charge the unit, connect it to a USB charger using a standard
Micro-USB cable (not included). Note that it is best using USB cable (not included). Note that it is best using an
android phone charger unit for this purpose.
4. Connect the micro-USB end of the cable to the
the Signal Board (image #22). Connect the other end of the cable to
a USB port or USB charger.
5. The unit should start charging and the The unit should start charging and the LED Indicator should start
flashing green.
6. Make sure to keep the unit turned Make sure to keep the unit turned on during charging.
7. When charging is complete, the When charging is complete, the LED Indicator stops flashing and remains green
8. Disconnect the cable and turn the unit off using the power switch on the Signal Board to save Disconnect the cable and turn the unit off using the power switch on the Signal Board to save Disconnect the cable and turn the unit off using the power switch on the Signal Board to save
battery power. If the unit is left turned on, the battery will battery power. If the unit is left turned on, the battery will drain within a few days.
9. During charging, keep the charger away from highly flammable materials or products and never
leave the charger unattended when in use leave the charger unattended when in use.
10. Never apply any type of pressure on the battery, expose it to direct heat or chemicals. Never apply any type of pressure on the battery, expose it to direct heat or chemicals. Never apply any type of pressure on the battery, expose it to direct heat or chemicals.
(Housing Back Door Exterior)* (Housin
Vacuum
Release Tip
for this purpose.
SB end of the cable to the Micro-USB port on
Connect the other end of the cable to
keep the charger away from highly flammable materials or products and never keep the charger away from highly flammable materials or products and never
Vacuum Valve
stops flashing and remains green.
drain within a few days.
FRX100 VA R Housing Instruction Manual
25
Image #22 Image #
Instruction Manual 20200225