Fantasea Line FRX100 VA R Instruction Manual page 8

Front Side of Housing -
10. Lanyard Loop
6. Fiber Optic Cable Plate-
a. When installed on the housing, the fiber optic cable plate and the two adaptors inserted
inside it allow for an easy attachment of 2 fiber optic cables to the housing. For further inside it allow for an easy attachment of 2 fiber opt
instructions, please refer to the section "External Flashes". instructions, please refer to the section "
b. Remove the fiber optic cable plate from the housing in order to make use of the internal Remove the fiber optic cable plate from the housing in order to make use of the internal Remove the fiber optic cable plate from the housing in order to make use of the internal
camera flash during your dive. In order to remove the plate, insert
adaptors installed inside the plate and pull the plate upwards till it is removed from its slot. adaptors installed inside the plate and pull the plate upwards till it is removed from its slot. adaptors installed inside the plate and pull the plate upwards till it is removed from its slot.
Note that when photographing using the camera built
accessory should be installed, or else unwanted shading will occur in most images taken. accessory should be installed, or else unwanted
c. Make sure the fiber optic cable plate i Make sure the fiber optic cable plate is secured to the housing by its secure line
avoid losing it during the dive. avoid losing it during the dive.
d. If using only one external flash If using only one external flash, make sure the second fiber optic cable adaptor rema
place to block any light coming out of the exposed adaptor hole. place to block any light coming out of the exposed adaptor hole.
Corresponding numbered descriptions are found below the image Corresponding
9. Tripod Mounting Screw Holes Tripod Mounting Screw Holes
(bottom) (bottom)
on the housing, the fiber optic cable plate and the two adaptors inserted on the housing, the fiber optic cable plate and the two adaptors inserted
flash during your dive. In order to remove the plate, insert your fingers beneath the
when photographing using the camera built-in flash only, the flash diffuser
ic cables to the housing. For further
shading will occur in most images taken.
s secured to the housing by its secure line in order to
make sure the second fiber optic cable adaptor remains in its
FRX100 VA R Housing Instruction Manual
8
below the image
6. Fiber Optic
7. Control Ring
8. Lens Port
your fingers beneath the
in flash only, the flash diffuser
Instruction Manual 20200225
Cable Plate