Fantasea Line FRX100 VA R Instruction Manual page 18

the inside.
6. Using your second hand, install the plastic Using your second hand, install the plastic C-shaped washer on the control shaft. First, using
small needle nose pliers, hold the
the housing backdoor and the
push the C-shaped washer against the shaft until it snaps
7. Finally, re-install the black rubber
until it is fully and securely seated.
protruding points at the end of the black plastic 2
8. Once complete, install the camera inside the housing and test to control. If properly installed,
the control should work smoothly when turned or pushed against the camera button. the control should work smoothly when turned or pushed against the camera button. the control should work smoothly when turned or pushed against the camera button.
9. The C-shaped washer should remain in this position as long as the housing is used to
accommodate the RX100 III camera. e the RX100 III camera. In case of using the housing to accommodate the RX100 IV
or RX100 V camera, the C-shaped washer
Important Notice: This procedure should only be followed if using the housing to accommodate the Important Notice: This procedure should only be followed if using the housing to accommodate the Important Notice: This procedure should only be followed if using the housing to accommodate the
RX100 III camera. Installing the C-shaped washer
RX100 V camera will interfere with housing functionality and potentially damage the camera camera will interfere with housing functionality and potentially damage the camera camera will interfere with housing functionality and potentially damage the camera
and/or housing!
, hold the C-shaped washer against the shaft so it's position
and the black plastic 2 pointed seat installed at the end of the shaft. Then
against the shaft until it snaps securely into place (image #1
Image # Image #11
rubber disc at the end of the control by pushing it against the shaft at the end of the control by pushing it against the shaft
seated. Do so by mounting the 2 holes on the disc center onto the 2 by mounting the 2 holes on the disc center onto the 2
the end of the black plastic 2-pointed seat.
ll the camera inside the housing and test to control. If properly installed, ll the camera inside the housing and test to control. If properly installed,
should remain in this position as long as the housing is used to should remain in this position as long as the housing is used to
case of using the housing to accommodate the RX100 IV
shaped washer should be removed.
shaped washer when using the housing with the RX100 IV
against the shaft so it's positioned between
installed at the end of the shaft. Then
Housing
backdoor
C-shaped
washer
Black plastic 2-
pointed seat at
end of shaft
when using the housing with the RX100 IV /
FRX100 VA R Housing Instruction Manual
18
shaft. First, using
(image #12).
Image #12
Instruction Manual 20200225