Using The Camera Built -I N Flash - Fantasea Line FRX100 VA R Instruction Manual

4. Open the housing as described sing as described in the section "Opening the Housing" and carefully remove
camera from the housing. Take sufficient care that no water drips from your hair and body onto
the housing and camera.
USING THE CAMERA BUILT-IN FLASH
1. Sony RX100 cameras have a built
stronger lighting, illuminating subjects that are farther away,
shadowing effects and photographing in deep water, an accessory slave flash is re shadowing effects and photographing in deep water,
further information, please refer to the section "External Flashes". further information, please refer to the section "External Flashes"
2. In order to make use of the built In order to make use of the built-in camera flash, remove the Fiber Optic Cable Plate from the
housing. Insert your fingers beneath the adaptors installed inside the pla nsert your fingers beneath the adaptors installed inside the plate and
upwards till it is removed from its slot. Make sure the upwards till it is removed from its slot. Make sure the
fiber optic cable plate is secured to the housing by the fiber optic cable plate is secured to the housing by the
dedicated secure line in order to avoid losing it during
the dive.
3. The removable flash diffuser included assists with
softening the built-in flash output, increasing its angle
of coverage and decreasing the amount of of coverage and decreasing the amount of
backscatter in the images (the unattractive
snowstorm effect of the flash reflecting off suspended
particles in the water).
a. In order to install the re In order to install the removable flash
diffuser, hold the diffuser above the housing diffuser, hold the diffuser above the housing
lens port with the diffuser pointing upwards lens port with the diffuser pointing upwards
(image #19).
b. Gently push the diffuser ring Gently push the diffuser ring downwards
and against the housing lens port against the housing lens port until it
clicks (image #20).
c. Attach the flash diffuser quick release Attach the flash diffuser quick relea
secure string to the other side of the string secure string to the other side of the string
connected to the housing in order to avoid connected to the housing in order to avoid
losing the flash diffuser underwater. losing the flash diffuser underwater.
d. In order to remove the flash diffuser from In order to remove the flash diffuser from
the housing, gently pull it the housing, gently pull it upwards and
away from the lens port until it snaps out away from the lens port
of place.
Take sufficient care that no water drips from your hair and body onto Take sufficient care that no water drips from your hair and body onto
IN FLASH
a built-in flash capable of illuminating nearby underwater subjects.
subjects that are farther away, avoiding backscatter, eliminating
in order to avoid losing it during
included assists with
in flash output, increasing its angle
the unattractive
of the flash reflecting off suspended
nearby underwater subjects. For
avoiding backscatter, eliminating
an accessory slave flash is recommended. For
flash, remove the Fiber Optic Cable Plate from the
FRX100 VA R Housing Instruction Manual
22
carefully remove the
te and push the plate
Image #19
Image #20
Instruction Manual 20200225