to the housing by tying its secure string
to the housing by tying its secure string around the lower rectangular loop at the bottom
around the lower rectangular loop at the bottom
left side of the housing.
left side of the housing. Install the anti-glare hood over the anti-glare hood r
glare hood rails at the
back of the housing. First install the anti
back of the housing. First install the anti-glare hood over the top rail (image #3) and then
glare hood over the top rail (image #3) and then
gently and carefully stretch it downwards to install it on the bottom rail
gently and carefully stretch it downwards to install it on the bottom rail
gently and carefully stretch it downwards to install it on the bottom rail, making sure it's
sitting securely on both upper and lower rails
securely on both upper and lower rails (image #4).
f. It is important that a first dive with the housing is
first dive with the housing is always made without the camera in
made without the camera in
order to verify that the housing watertight seal has not been affected during transport
order to verify that the housing watertight seal has not been affected during transport
order to verify that the housing watertight seal has not been affected during transport
and after long periods o
long periods of storage.
Image #1
Image #2
Image #3
Image #4
FRX100 VA R Housing Instruction Manual
Instruction Manual 20200225
14