Fantasea Line FRX100 VA R Instruction Manual page 27

turning it clockwise until reaching a point of resistance. Use only the wrench included and do not turning it clockwise until reaching a point of resistance.
over tighten the Vacuum Valve to prevent the port, valve or housing back door from over tighten the Vacuum Valve to prevent the port, valve or housing back door from being damaged. over tighten the Vacuum Valve to prevent the port, valve or housing back door from
Performing a Pre-Dive Check
1. Prior to closing the housing, turn the unit on using the po Prior to closing the housing, turn the unit on using the power switch on the Signal Board. The
switch should be pushed leftwards in order for the unit to be turned on. Make sure the unit is switch should be pushed leftwards in order for the unit to be turned on. Make sure the unit is switch should be pushed leftwards in order for the unit to be turned on. Make sure the unit is
properly charged and that the LED indicator flashes slowly (approx. 1 flash per second). properly charged and that the LED indicator flashes slowly (approx. 1 flash per second). properly charged and that the LED indicator flashes slowly (approx. 1 flash per second).
2. Lock the housing and all other acce
watertight seal of the housing. watertight seal of the housing. Camera should be turned off prior to the pre-
Important Notice
3. Remove the protective cap from the Vacuum Valve by gent Remove the protective cap from the Vacuum Valve by gently turning it counterclockwise and
screwing it out (image #24). Make sure you're only removing the protective cap when
rather than the complete valve. If the valve screws out together with its cap, use the wrench rather than the complete valve. If the valve screws out together with its cap, use the wrench rather than the complete valve. If the valve screws out together with its cap, use the wrench
included in order to tighten the valve inside the port. This will allow for easy and safe removal of
the protective cap when screwed out. the protective cap when screwed out.
Image #24
4. Install the Rubber Fitting on the Vacuum Install the Rubber Fitting on the Vacuum
Pump. Hold the Rubber Fitting against the Pump. Hold the Rubber Fitting against the
Vacuum Pump so its wide opening faces the Vacuum Pump so its wide opening faces the
funnel of the pump. Insert the funnel of the of the pump. Insert the funnel of the
pump into the Rubber Fitting and then push pump into the Rubber Fitting and then push
the fitting against the funnel until it is fully the fitting against the funnel until it is fully
inserted (image #25).
all other accessories which their installation might have an effect on the ssories which their installation might have an effect on the
The housing should be completely set up for the dive prior to performing the The housing should be completely set up for the dive prior to performing the The housing should be completely set up for the dive prior to performing the
vacuum pre- -dive check. Any modifications carried out on the housing after the ive check. Any modifications carried out on the housing after the
pre-dive test has been completed necessarily turn the check results irrelevant dive test has been completed necessarily turn the check results irrelevant dive test has been completed necessarily turn the check results irrelevant
and require performing an additional pre-dive check. and require performing an additional pre
Make sure you're only removing the protective cap when turning it, Make sure you're only removing the protective cap when
e valve inside the port. This will allow for easy and safe removal of e valve inside the port. This will allow for easy and safe removal of
Use only the wrench included and do not
wer switch on the Signal Board. The
ly turning it counterclockwise and
FRX100 VA R Housing Instruction Manual
27
-dive check.
Image #25
Instruction Manual 20200225