Checking The O-Ring - Fantasea Line FRX100 VA R Instruction Manual

CHECKING THE O-RING

1. Prior to each closure of the hous Prior to each closure of the housing, the back door black O-ring should be visually inspected. If there
is any debris present, including dirt, sand, dust, hair
ensure a proper watertight seal. ensure a proper watertight seal.
2. In order to clean the black O-ring, first remove it
a. Insert the O-ring remover between the
seated in (image #7 on the following page
b. Slip the tip of the inserted O Slip the tip of the inserted O-ring remover below the black O-ring, while making sure the O
doesn't get damaged (image #
c. Carefully hold the O-ring with your fingertips in order to remove it from the groove.
3. Cleaning the O-ring is a simple matter of wiping it with a da
matter. Be careful the cloth you use does not leave any of its own material behind as this can also
affect the effectiveness of the seal. affect the effectiveness of the seal
4. Apply a slight layer of silicone grease on the Apply a slight layer of silicone grease on the black O-ring. Please note that the amount of lubrication
required on the O-ring is only en
twist or become dislodged. More grease is not necessarily better, and in some cases might twist or become dislodged. More grease is not
with the watertight seal of the housing. with the watertight seal of the
5. When replacing the O-ring, place it back into
into the groove all around the housing until it is all seated in the groove and no part of it is sticking into the groove all around the housing until it is all seated in the groove and no part of it is sticking into the groove all around the housing until it is all seated in the groove and no part of it is sticking
up or out of the groove.
cluding dirt, sand, dust, hair or any other matter, it must be cleaned to
ring, first remove it from the housing:
ring remover between the black O-ring and the groove it is
on the following page).
mage #8 on the following page).
ring with your fingertips in order to remove it from the groove. ring with your fingertips in order to remove it from the groove.
ring is a simple matter of wiping it with a damp, soft cloth to remove the
he cloth you use does not leave any of its own material behind as this can also he cloth you use does not leave any of its own material behind as this can also
ring is only enough to allow it to slip into place without friction, so it does not ough to allow it to slip into place without friction, so it does not
ring, place it back into the groove starting at one corner and gently pressing it
ring should be visually inspected. If there
other matter, it must be cleaned to
Image #7
mp, soft cloth to remove the foreign
Please note that the amount of lubrication
the groove starting at one corner and gently pressing it
FRX100 VA R Housing Instruction Manual
16
ring, while making sure the O-ring
Image #8 Image #
in some cases might interfere
Instruction Manual 20200225