Setting The Tally Display; Other Display Settings - Panasonic AV-HS6000 Series Operation Manual

Setting the tally display

Configure the tally display setting to be superimposed onto the split frame of the MultiView display.
1
Select the <MV> button → [MV1‑4] → [MV1] to [MV4] tabs.
2
Select an item in [Tally Group1] to [Tally Group4] in the [Tally Box]/[Tally Label L]/[Tally Label R] column.
[On]
[Off]
@ NOTE
t If conditions overlap, the following priority order is used:
[Tally Group1] > [Tally Group2] > [Tally Group3] > [Tally Group4]
t To set the tally color, select the <SYS> button on the top menu → [PERIPHERAL] → [Tally] tab → [Tally Group2-1] to [Tally Group4-1] columns →
[Color].
t For details on the tally group settings, refer to "Setting a tally" (page 153).

Other display settings

Setting the level meter
Level meters for the embedded audio signals transferred by the SDI input can be displayed on the split screens.
f Display on the left: Channel 1 of group 1
f Display on the right: Channel 2 of group 1
1
Select the <MV> button → [MV1‑4] → [MV1] to [MV4] tabs.
2
Select an item in [Level Meter] in the [Display] column.
[Off]
[On]
Setting the input signal mark
The status of the input signals can be displayed in front of the source names displayed on the split screens.
f [F] mark: Indicates that the input signals are frozen.
f [!] mark: Indicates that there are no input signals or signals with different formats are input. If horizontal pixels are the same, false detection may occur.
1
Select the <MV> button → [MV1‑4] → [MV1] to [MV4] tabs.
2
Select an item in [Input Status] in the [Display] column.
[On]
[Off]
f When the [F] mark is displayed, the [!] mark is not displayed.
Setting the marker
Safety markers can be displayed for PGM and PVW sources of the MultiView display.
1
Select the <MV> button → [MV1‑4] → [MV1] to [MV4] tabs.
2
Select an item in [Marker] in the [Display] column.
f Configure the marker display setting.
[Off]
[4:3]
[16:9]
3
Set [Marker Size] in the [Display] column.
f Set the marker size.
Chapter 6 Input/Output Signal Settings — Setting MultiView displays
[Tally Label L]
[Source Name]
Shows the tally displays.
Does not show the tally displays.
Does not display the level meter.
Displays the level meter.
Displays the input signal status.
Does not display the input signal status.
Does not display the markers.
Displays the markers using the 4:3 aspect ratio.
Displays the markers using the 16:9 aspect ratio.
SDI IN 1
– 128 –
[Tally Box]
[Tally Label R]