Moving image data handled by the unit is in the original format. "clp" is added to the extension of the file (clip file) for exchanging data using a memory

card or a computer.

The sequential numbered still image files (TARGA format (tga)) can be converted to a clip file using a computer that has the AV‑HS6000 ClipConvert

software installed. Also, it can be made into a clip file with audio data when an audio file (WAV format (extension .wav)) is loaded at the time of

conversion.

For the AV-HS6000 ClipConvert software,visit the following website.

http://pro-av.panasonic.net/ (English only)

r Operation screen of the ClipConvert software

1 "High"/"Standard"

Select the image quality of the clip file to be generated.

High: Approximately 200 Mbps, Standard: Approximately 100 Mbps (other than 1080/59.94p, 1080/50p)

High: Approximately 400 Mbps, Standard:Approximately 200 Mbps (1080/59.94p, 1080/50p)

2 "Frame"

Select the frame rate of the clip file to be generated.

The clip file with different frame rate from the AV‑HS6000 system format cannot be loaded by AV‑HS6000.

In the interlace mode and PsF mode, one file is expanded into two fields; and in the progressive mode, one file is equivalent to one frame.

3 "alpha"

Select this check box when converting images with key signals.

4 "Convert"

Select a TARGA file.

f The TARGA files will be grouped when the TARGA files are in sequential number, and the name in front of the number will be displayed as the file

name. To recognize as TARGA files in sequential number, add four digit numbers starting with 0001 in sequence after the file name excluding the

file extension in advance.

f To generate a clip file with audio data, save the audio file (extension .wav) in the same folder as the folder where the TARGA files are saved. At this

time, set the name of the audio file (part excluding the extension .wav) same as the name of the TARGA files (excluding the sequential number and

extension .tga). The audio file with different name from the TARGA files is not loaded, and audio data will not be embedded in the clip file.

f Example) A clip file with audio data can be created by preparing following files and saving in the same folder.

- picture0001.tga - picture0011.tga

- picture.wav

5 "Save"

Specifies the destination and file name of the clip file to be generated.

The file name omitted in the display at the time the clip file is loaded to AV‑HS6000 when a file name exceeding 8 characters (excluding file

extension). It is recommended to specify the file name with 8 characters or less.

6 "Convert"

Executes the conversion. The clip file is generated when executed.

7 "Cancel"