Setting The Sync Signal; Other Video Signal Settings - Panasonic AV-HS6000 Series Operation Manual

Example 2)
Input signal (Non-synchronized)
Sync signal (Reference)
Output signal 1
Output signal 2 (90H)
Output signal 2 (1F)

Setting the sync signal

The sync signal to be used by the system can be selected.
In external synchronization, it is synchronized with an external sync signal. (Genlock)
The Reference input signal is output using the loop-through method.
1
Select the <SYS> button → [SYSTEM] → [Video] tab.
2
Select an item in [Sync] in the [Reference] column.
f Select the sync signal.
[BB]
[BB Advanced]
[Tri‑level sync]
[Internal]
f When the system format is 1080/24PsF, [Internal] cannot be selected in [Sync] in the [Reference] column.
f This unit supports synchronization signals for field frequencies that are the same as those of the system format.
However, when the system format is 1080/23.98PsF, black burst signals with 10 Field ID (SMPTE318M compliant) are also supported.
f When the system format is 1080/24PsF, [Tri-level sync] can only be selected.
3
Select an item in [BB Setup] in the [Reference] column.
f Select [7.5IRE] or [0IRE] for the setup level of the black burst signal in the internal synchronization mode.
This setting takes effect when the video system is 59.94i or 59.94p. It is fixed to [0IRE] when the video system is 50i or 50p.
4
Check the display in [Gen Lock] in the [Reference] column.
f Check the Genlock status.
[Unlocked]
[Locked]

Other video signal settings

Setting the amount of delay in video effects
A delay amount can be set for the background or key video.
1
Select the <SYS> button → [SYSTEM] → [Video] tab.
2
Select an item in [BKGD]/[Key] in the [Latency] column.
[Minimum]
Chapter 8 System Menu — System settings
F1
Max. of 1F -
90H
Max. of 1F
Max. of 2F - 90H
Black burst signal (vertical phase of 0H)
Black burst signal
When 59.94i or 59.94p is selected: Vertical phase of 90H
When 50i or 50p is selected: Vertical phase of 75H
Tri-level sync signal (vertical phase of 0H)
Synchronizes with an internal reference signal (INT).
Outputs the REFOUT signal (black burst signal) from the two <REF> terminals.
Not synchronized with the external sync signal or internal reference signal.
Synchronized with the external sync signal or internal reference signal.
The video is not delayed.
f However, the image will be delayed by one frame (1F) when [SQ], [SL], or [3D] is selected in wipe pattern.
F2
1F (frame)
F1 F2
F1 F2
– 144 –
F1