Table of Contents
Advertisement
Input/output signal settings
Setting the split frame and characters
Set the frame, character brightness and background of the
split screens to be displayed on the multi view display.
XPT
1 Press the
button to light its indicator, and display
MV
the Multi View Display menu.
2 Use [F1] to display the MV Frame sub menu.
3 Use [F2] to set the split frame brightness and split frame
display using the Frame item.
LUM0%,
Select one of these settings for the
LUM25%,
brightness of the split frame (gray scale).
LUM50%,
LUM75%,
LUM100%
Off
The split frame is not displayed.
4 Use [F3] to set the character brightness and character
display using the Character item.
LUM0%,
Select one of these character (gray scale)
LUM25%,
brightness settings.
LUM50%,
LUM75%,
LUM100%
Off
The characters are not displayed.
Neither is the character background shown.
5 Use [F4] to set whether the character background
(half-tone) is to be displayed using the Label item.
On
The character background is displayed.
Off
The character background is not displayed.
p This is enabled when Fit mode is on.
Setting the tally displays
Set the tally displays to be superimposed onto the split frame
of the multi view display.
You can set 4 tally groups on this unit, and you can set
materials for each of the groups.
Tally groups 1 and 2 can be displayed on the multi view
display.
CONF
1 Press the
button to light its indicator, and display
SYS
the System menu.
2 Use [F1] to display the Tally MV Color sub menu.
3 Use [F2] to [F5] to set the display color for Group1 to 4.
Group1
Fixed to Red.
Group2 to
Select one from Red, Green, Yellow, or
Group4
Orange.
4 Use [F1] to display the Tally Target sub menu.
5 Use [F2] to [F5] to select the material to allocate to
Group1 to 4.
PGM
Program video signal
PVW
Preview video signal
CLN
Clean signal
ME PGM
ME program video signal
KeyOut
Key output signal
AUX1
AUX1 bus output signal
AUX2
AUX2 bus output signal
AUX3
AUX3 bus output signal
AUX4
AUX4 bus output signal
XPT
6 Press the
button to light its indicator, and display
MV
the Multi View Display menu.
7 Use [F1] to display the Tally Group 1 / 2 sub menu.
p Groups 1 and 2 set in 1 to 5 above can be set to
display on the multi view display.
114
Advertisement
Table of Contents
