Connection (To Installation Personnel); Connecting The Imaging Systems; Connecting The Control Systems - Panasonic AV-HS6000 Series Operation Manual

Chapter 2 Installation and Connection (To installation personnel) — Connection (To installation personnel)

Connection (To installation personnel)

Connecting the imaging systems

<SDI IN 1> to <SDI IN 32>/<DVI‑D IN1>/<DVI‑D IN2> terminals
Connect cameras, VTR, and other external sources.
The SDI input of the Main Frame AV-HS60U1/AV-HS60U2 has a frame synchronizer function, and a non-synchronized SDI signal can be input. To
reduce image delay, set the frame synchronizer function to [Off], send a sync signal to the unit and the input device, and configure a synchronized
system.
<SDI OUT 1> to <SDI OUT 16> terminals
Connect the switcher output signal to monitors and other external devices.
HD-SDI monitor
<REF> terminal
Connect the system sync signal from the sync signal generator.
The loop-through output is performed in the external sync mode. If the loop-through output is not going to be used, provide a 75 Ω termination.
Black burst signals are output from both terminals in the internal sync mode.
Sync signal

Connecting the control systems

Connect the Control Panel AV-HS60C1/AV-HS60C2/AV-HS60C4, computer for menu operation, or external devices to the Main Frame AV-HS60U1/
AV-HS60U2.
The connection of the main control panel and the sub control panel is described here using the illustration of AV-HS60C1/AV-HS60C2.
AV-HS60C4 can also be connected in the same manner.
Camera
External sync mode
INT
– 15 –
Computer
Internal signal
generator
Internal sync mode