Table 66 Ehpm Alphanumeric Display Formats - Honeywell HPM Service

Condition Format
Test Txx
Sequence
Number
Format descriptions
Using the UCN node number conventions described earlier in this section, with TPN R684, the
alphanumeric display formats for an EHPM are described in the following table.

Table 66 EHPM Alphanumeric Display Formats

Format
STRT
Afnn
UCN
<this UCN node
number>
INDX
<this FTE device
index>
IP
<First IP address
octet>
<Second IP address
octet>
<Third IP address
octet>
<Fourth IP address
octet>
R688
December 2020
The display provides the hexadecimal test sequence number, "xx," which is performed
during a HPMM Startup. The test sequence numbers are unique for both the
Communications and Control processors. (See Table 4-1 for a complete list) The test
sequence numbers are displayed only when the detailed-display mode (switch) has
been previously enabled (since the last power cycle). Otherwise, the appropriate
generic message is displayed
(for example, STRT, Afnn, SWAP).
Begin Communications processor firmware based tests.
For an EHPM, depending on whether a BootP server is configured or not, the STRT
text may show for a longer time period.
A = Alive
f = actual physical position indicators (as "L" and "R" to indicate residency in a 7-Slot
card file and "1" and "2" to indicate residency in the file-1 and file-2 15-Slot
backpanels)
nn = user configured decimal UCN node number (01-64)
Indicates the successful Cold startup of the HPMM Communications processor. In this
state the Communications processor loops indefinitely while performing background
diagnostics and waiting for a UCN download to occur. The Control processor and I/O
Link processor are held initialized.
It is a text indication that the EHPM's UCN Node address is about to be displayed.
The EHPM's UCN Node address which is configured from its HPM backplane
switches.
The FTE device index. This indicates the value from the hardware's rotary switches.
The EHPM's FTE Device Index value.
Internet Protocol Address of the node. The last octet is set by the FTE device index.
The first octet of the IP Address.
The second octet of the IP Address.
The third octet of the IP Address.
The fourth octet of the IP Address. Matches the FTE Device Index from the EHPM
FTE Interface card's hardware rotary switches.
HPM High-Performance Process Manager Service
Description
Description
Honeywell
4 Fault Isolation
4.9 HPMM Alphanumeric Display
361