Table 26 Ucn Status Display - Load/Save Restore - Honeywell HPM Service

LOAD/SAVE RESTORE display targets
The command targets at the bottom of the display in Figure 98 perform the functions that are defined in
the following table.
Target
PROGRAM LOAD
RESTORE DATA
SAVE DATA
LADDER LOAD
LADDER SAVE
CANCEL
ENTER
R688
December 2020
Table 26 UCN Status Display – LOAD/SAVE RESTORE
Loads the program and data to the chosen UCN device.
The device must be in the Alive state. The command is
executed by selecting the ENTER target.
Restores the database to the chosen UCN device. The
device must be in the Idle state. The command is executed
by selecting the ENTER target.
Saves the database from the chosen UCN device into either
the History Module or removable media. This is sometimes
called "Checkpointing." The command is executed by
selecting the ENTER target.
This is a Logic Manager function.
This is a Logic Manager function.
Clears the LOAD PROGRAM, RESTORE DATA, SAVE
DATA, LADDER LOAD, LADDER SAVE, and ENTER
command targets from the display.
The ENTER target must be selected for the chosen
LOAD/SAVE RESTORE function to be executed.
HPM High-Performance Process Manager Service
Honeywell
3 UCN Status Displays
Function
3.4 Display Operation
195