Table 69 Alphanumeric Display For Startup/Factory Test Mode Sequence - Honeywell HPM Service

4 Fault Isolation
4.9 HPMM Alphanumeric Display
Detailed
Display
STRT
T 0D
T 13
T 17
T 1B
T 21
T 25
T 4F
A139
Startup/Factory Test mode sequence
If the Factory Test mode had been selected, the Startup sequence would end prior to LLC initialization as
listed in the following table for the Detailed-display mode and non-Detailed Display mode.

Table 69 Alphanumeric Display for Startup/Factory Test Mode Sequence

Detailed
Display
STRT
T 0D
T 13
T 17
T 1B
T 21
T 25
T 4C
AR00
FTST
AR00
FTST
Startup/HPMM failure sequence
An HPMM failure occurs during or after a Startup results in alternating failure and Communications
processor Hard failure code. This is dependent upon whether the Detailed Display mode (switch) is
enabled. The description in the following table is an example of a sequence when a spurious interrupt
failure occurs listing both the Detailed Display mode and non-Detailed Display mode.
364
Non-Detailed
Display
STRT Begin Communications processor firmware based
tests.
STRT Global DRAM EDAC sweep
STRT Global DRAM initialization
STRT Comm Local RAM destructive pattern test
STRT Comm Local RAM initialization
STRT UCN TBC Private RAM destructive pattern test
STRT UCN TBC Private RAM Initialization
STRT Initialize the (FW resident) LLC Communications layer
A139 Alive state (file 1, UCN node 39)
Non-Detailed
Display
STRT Begin Communications processor firmware based
tests.
STRT Global DRAM EDAC sweep
STRT Global DRAM initialization
STRT Comm Local RAM destructive pattern test
STRT Comm Local RAM initialization
STRT UCN TBC Private RAM destructive pattern test
STRT UCN TBC Private RAM Initialization
STRT Transition to the FW Alive state
AR00 Alive state (UCN node 00, Right file position)
FTST Factor Test mode notification
AR00 Status is displayed for 1/2 second.
FTST Notification is displayed for 1/2 second.
HPM High-Performance Process Manager Service
Honeywell
Description
Description
R688
December 2020