Table of Contents
Advertisement
Bottom of display
The information at the bottom of the IOP Detail Status display varies. It is dependent on the IOP type.
For example, in Figure 143, "CALIBRATION NOT PERMITTED, MODULE NOT IN IDLE" appears
for the HLAI IOP.
IOP configuration
The first line of the display indicates the IOP type (HLAI, LLAI, DI, etc.), primary or secondary HPMM
(PRIMARY or SECONDARY) or Non-redundant, and whether the IOP is configured as A or B
(IOM_A or IOM_B).
The remaining information in this area is defined in the following table. The status in this area is updated
every 4 seconds.
Term
UCN
HPM
MODULE
PHYS ADDR
FILE
CARD
STS
ACTUAL TYPE
FTA CONNECT
WITH BIAS
HARDWARE REV
FIRMWARE REV
LAST HARD
FAILURE
DESCRIPTION
R688
December 2020
Table 52 IOP Detail Status Display – IOP Configuration
The network number.
The HPM address on the UCN.
The "soft" (logical) address of the IOP in the HPM configuration
(1-40).
The hardware address of the IOP on the I/O Link.
The card file position of the IOP in the HPM.
The slot position of the IOP in the card file.
The current status of the IOP
(SOFTFAIL, OK, IDLE, IDLESF, NR).
The IOP type read from the IOP
(HLAI, LLAI, DI, DO, DO_32, LLMux, RHMUX, STIM, STI, PI,
SDI, SI, AO, or AO_32).
The connector on the FTA that is in use
(CONN_A or CONN_B).
Is the acting primary IOP the preferred IOP (YES or NO)?
A hexadecimal byte that shows the current revision of the IOP
hardware.
Two hexadecimal digits in the form "x.x" that shows the current
firmware revision.
The last Hard failure detected by the IOP. The mnemonic in this
field serves as an entry into Table 61 in the "Fault Isolation"
section.
If the IOP is a "High Density" IOP, such as a model MU-PDIY22
IOP, a description of the associated FTA will be included. Two
types of FTA can be connected to the IOP (24 V or 240 V).
HPM High-Performance Process Manager Service
Honeywell
3.8 IOP Detail Status Displays
Description
3 UCN Status Displays
263
Advertisement
Table of Contents
Troubleshooting
