Iol Cable Commands Display Targets; Table 41 Hpm Status Display - Iol Cable Commands - Honeywell HPM Service

3 UCN Status Displays
3.5 HPM Status Displays

IOL CABLE COMMANDS display targets

The command targets at the bottom of the display in Figure 113 perform the functions defined in the
following table.
Target
SELECT CABLE A
SELECT CABLE B
ENABLE SWAP
DISABLE SWAP
ALL MODULES
CANCEL
ENTER
222
Table 41 HPM Status Display – IOL CABLE COMMANDS
Activates I/O Link (IOL) cable A. The command is executed
by selecting the ENTER target.
Activates I/O Link (IOL) cable B. The command is executed
by selecting the ENTER target.
Enables periodic swapping of the I/O Link cables. The
command is executed by selecting the ENTER target.
Disables periodic swapping of the I/O Link cables. The
command is executed by selecting the ENTER target.
Allows both HPMMs and all IOPs to be affected by the cable
function command. The command is executed by selecting
the ENTER target.
Clears the SELECT CABLE A, SELECT CABLE B, ENABLE
SWAP, DISABLE SWAP, ALL MODULES, and ENTER
command targets from the display.
The ENTER target must be selected for the chosen IOL
CABLE COMMANDS function to be executed.
HPM High-Performance Process Manager Service
Honeywell
Function
R688
December 2020