Figure 3-65 Hdd Setting Configuration Interface; Figure 3-66 Channel Settings Configuration Interface - Honeywell HEN04111 User Manual

120 | Embedded Network Video Recorder User Guide
2.
3.
Configuring HDD Channels
1.
2.
www.honeywell.com/security
The HDD Setting configuration interface appears.
Figure 3-65 HDD Setting Configuration Interface
The HDD No. column shows the maximum number of HDD you can install.
If the serial number is highlighted, then you can connect to that HDD.
If the serial number is not highlighted, then you can not connect to that HDD.
Select a HDD group name from the HDD Group drop-down list.
The HDD Group column shows the HDD Group number of the current hard disk.
Click OK to save these new settings.
Note A HDD can belong to only one group. But one group can contain many HDDs.
The HDD No. corresponds to the HDD port. The HDD Group No. can change if
you change the HDD.
Note When you change the HDD Group settings, the system will save the recorded
video and snapshots, then reboot.
Click HDD Channel on the HDD MANAGE configuration interface. The Channel Settings
configuration interface appears.
Figure 3-66 Channel Settings Configuration Interface
Configure the HDDs for the main stream, the extra stream, and for snapshots as well. The
main and extra stream configurations for one channel can be saved to different groups.
Channel: Displays the actual channel number for the current NVR.