Honeywell HPM Service page 160

2 Equipment Description
2.27 EUCN Cable System
Initial Switch set up using "Express Setup"
System LED
Blinking green
Solid green
Red
Setup LED
Blinking green
Solid green
Port LED
Blinking green
Pwr A LED
Solid green
Dark (Off)
Verifying Port Connectivity
After the switch port is connected to another device.
Port LED
Amber
Solid green
Dark (Off)
Normal Operating Mode
The switch is completely configured and connectivity with the target device is already established.
Flashing green
Flashing green interspersed with flashing amber
OR solid amber
160
LED Color
LED Color
LED Color
LED Color
LED Color
LED Color
HPM High-Performance Process Manager Service
Honeywell
Description
The switch power-on self-test (POST) is running.
POST has completed.
The switch has failed POST.
Description
The switch is not configured.
Start a browser session on the PC.
Description
The switch Express Setup button is pressed.
A Category 5 Ethernet cable connects the blinking
switch port to the Ethernet port on a PC.
Description
The switch is properly powered up.
The switch is not powered up.
Description
The switch is establishing a link to the connected
device. This process takes about 30 seconds.
The switch and target device have established a
link.
The target device might not be turned on or there
might be a cable problem.
Description
Communication between the port and target
device is occurring.
A problem exists with this port to target device
interface.Check the port configuration and cable
integrity. If OK and condition still persists, contact
R688
December 2020