AMX Modero NXD-700Vi Operation/Reference Manual page 48

The following table lists the pinouts, signals, and pairing associated with the Ethernet connector.
Pin Signals Connections Pairing
1 TX + 1 --------- 1
2 TX - 2 --------- 2
3 RX + 3 --------- 3
4 no connection 4 --------- 4
5 no connection 5 --------- 5
6 RX - 6 --------- 6
7 no connection 7 --------- 7
8 no connection 8 --------- 8
FIG. 19 diagrams the RJ-45 pinouts and signals for the Ethernet RJ-45 connector and cable.
FIG. 19 RJ-45 wiring diagram
The NXD-700Vi panel can have up to two USB-capable input devices connected for use on its different
firmware and TPD4 panel pages. These input devices can consist of a keyboard or mouse.
USB-connected input devices are not detected and recognized by the panel until
power is cycled to the unit.
A mini-USB connection is only detected after it is installed onto an active
panel. Connection to a previously powered panel, allows the PC to detect the
panel and assign an appropriate USB driver.
1. Insert the input device USB connectors into the appropriate USB connector on the panel.
2. Press the on-screen Reboot button from the Protected Setup page to save any changes and restart
the panel.
3. After the panel splash-screen disappears:
If a USB mouse has been connected, a mouse cursor appears on the panel screen and its
location corresponds to the mouse cursor position sent by the external USB mouse.
If a USB keyboard has been connected, only on-screen keyboards and keypads will reflect any
external keystrokes sent from the external USB keyboard.
Color
1 --------- 2 Orange-White
Orange
3 --------- 6 Green-White
Blue
4 --------- 5 Blue-White
Green
7 --------- 8 Brown-White
Brown
1 2 3 4 5 6 7 8
1 2 3 4 5 6 7 8