AMX Modero NXD-700Vi Operation/Reference Manual page 37

Trim
Ring
Latches
No-Button Trim Ring
Faceplate
(outside surface shown)
FIG. 9
5. From along the internal surface of the Faceplate, install the six buttons by firmly inserting them into
the button openings until the Button latch secures the button in place (FIG. 9).
6. Install the pair of clear light pipe strips by pushing light pipes over the two black light pipe latches.
7. Grasp the Button Trim Ring on both sides and fit it into the groove along the outside surface of the
Faceplate (made available by the removal of the previous Trim Ring).
8. Gently insert the Button Trim Ring latches into their corresponding openings on the outer surface of
the internal Faceplate (FIG. 10).
Button Trim Ring
Button openings
FIG. 10
9. Firmly press down around the Button Trim Ring until all of the latches are securely inserted into
their openings on the Faceplate, and the Button Trim Ring is securely fastened. Verify the Button
Trim Ring is firmly inserted onto the Faceplate and that there are no gaps between this Trim Ring
and the outer surface of the Faceplate.
NXD-700Vi Panel/enclosure
Light Pipe latch
(black)
Button and Light Pipe removal
(showing the internal surface of Faceplate)
Faceplate (outer surface shown)
Button latch