AMX Modero NXD-700Vi Operation/Reference Manual page 125

Light Sensor: Allows you to monitor and alter the sensitivity of the Modero panel light sensor:
• The Light Sensor Level field indicates the level used to report the light
• The Light Sensor Level Port field indicates the port used to report the light
• The Light Sensor Channel field indicates the level used to report the sensor
• The Light Sensor Channel Port field indicates the port used to report the
• The Light Level field provides a numeric value representing the current value
• The Light Level bargraph displays a horizontal bargraph indicating the current
• Use the Dim Mode Max Level bargraph to alter the Maximum DIM level
• Use the Dim Mode Min Level bargraph to alter the Minimum DIM level value
Dim Mode Minimum Allows you to alter the sensitivity of the Modero panel light sensor:
Brightness:
• Toggle the Enable/Enabled button to either active/inactive the DIM Mode
• Use the DIM Mode Brightness UP/DN buttons to alter the DIM level.
• The DIM Mode Minimum Brightness bargraph indicates the current DIM
Motion Sensor: Provides the following fields:
• The Motion Detection field displays a reactive button that changes color
• The Motion Sensor Port field indicates the port used to report the motion
• The Motion Sensor Channel field indicates the channel used to report the
sensor level back to the NetLinx Master (set in TPD4) (read-only).
sensor level back to the NetLinx Master (set in TPD4) (read-only).
channel back to the NetLinx Master (set in TPD4). It is On when you are
below the Maximum dim mode level (read-only).
sensor channel back to the NetLinx Master (set in TPD4) (read-only).
of the light level detected by the on-board photo-sensor.
value of the light level detected by the on-board photo-sensor. This bargraph
provides a visual representation of the numeric value displayed within the
Light Level field.
value used to activate the DIM Mode Brightness Level (range = 0 - 100).
used to activate the DIM Mode Brightness Level (range = 0 - 100).
- The position of this bargraph can never exceed that of the Dim Mode
Max Level.
feature:
- Enable - activates this feature. Once active (by receiving a value below the
Dim Mode Min Level value), the current light level ramps to the DIM Mode
value within a few seconds.
- Enabled - (illuminated when selected) deactivates this feature.
- Range = 0 - 100.
- The lower the value, the darker a room must be before the LCD Brightness
value changes to conform to a DIM room (and vice versa with a higher
value).
Mode Brightness level.
- This level corresponds to the brightness level of the LCD used when
the DIM Mode is active.
- The Brightness value of the panel in a DIM room (low-light) is much
less than that of a Non-DIM (well to brightly-lit) where the LCD Brightness
must be higher to display the screen content clearly.
(illuminates) and displays the words "Motion Detected" when motion is
detected by the Modero panel's front motion sensor.
sensor channel back to the NetLinx Master (set in TPD4) (read-only).
motion sensor channel back to the NetLinx Master (set in TPD4) (read-only).