Cbx Connection Box Pinout - Datalogic Matrix 320 Product Reference Manual

CBX CONNECTION BOX PINOUT

The table below gives the pinout of the CBX100/500 terminal block connectors. Use this
pinout when the Matrix 320 reader is connected by means of the CBX100/500:
Group
Input
Power
Inputs
Outputs
Auxiliary
Interface
ID-NET
Main
Interface
* Do not leave floating, see
Label Description
Vdc Power Supply Input Voltage +
GND Power Supply Input Voltage -
Earth Protection Earth Ground
+V Power Source - External Trigger
I1A External Trigger A (polarity insensitive)
I1B External Trigger B (polarity insensitive)
-V Power Reference - External Trigger
+V Power Source - Inputs
I2A Input 2 A (polarity insensitive)
I2B Input 2 B (polarity insensitive)
-V Power Reference - Inputs
+V Power Source - Outputs
-V Power Reference - Outputs
O1+ Output 1 + opto-isolated and polarity sensitive
O1- Output 1 - opto-isolated and polarity sensitive
O2+ Output 2 + opto-isolated and polarity sensitive
O2- Output 2 - opto-isolated and polarity sensitive
O3A Output 3 - non opto-isolated (only available through CBX500)
TX Transmit Data
RX Receive Data
SGND Auxiliary Interface Signal Ground
REF Network Reference
ID+ ID-NET network data +
ID- ID-NET network data -
Shield Network Cable Shield
RS232
TX TX+
RX *RX+
- TX-
- *RX-
SGND SGND
RS422 Full Duplex Interface" on page 65
"
CBX CONNECTION BOX PINOUT
RS422 Full Duplex
for connection details.
PRODUCT REFERENCE GUIDE
61