Datalogic Matrix 320 Product Reference Manual page 160

SOFTWARE CONFIGURATION
Diagnostic Alarms
Diagnostic error messages are sent to the BM150 display as numeric Alarm Codes (even
if Failure Messages are selected for data transmission the numeric Alarm Code is sent to
the display).
X = numeric Alarm Code (see below for the list of Alarm Codes)
R = Device Network Type – MUL=Multidata, SYN=Synchronized, ALN=Alone
N = Device Network Setting – M00=ID-NET Network Master, Sxx= ID-NET Network Slave
address, Null string= Alone (no network)
Alarm Code
1
64
171
185
187
189
191
193
195
201
Slave Node Alarms (Master only)
X = slave node number (1-31)
R = Device Network Type – MUL=Multidata, SYN=Synchronized
Network State (Master only)
M = Master diagnostic condition; S = Slave diagnostic condition:
* = scanner OK
- =scanner not detected at startup
? =scanner detected at startup but not responding to diagnostic polling
! = scanner diagnostic error
146
MATRIX 320
Description
Slave No Reply
Slave Address Duplication
Protocol Index Failure
Backup Memory Communication Failure
Wrong Rotary Switch Selection
Fieldbus Communication Failure
Fieldbus Type Mismatch
Fieldbus Configuration Error
Fieldbus DHCP Problem
No XRF Slave(s) Detected