Restore; Replacement - Datalogic Matrix 320 Product Reference Manual

Restore

To perform a Restore:
1. From the DL.CODE Device menu, select either Single Reader Restore (from file on
NOTE
If restoring an ID-NET network though the Master, this may take a few minutes.
At the end of the restore, DL.CODE shows a message indicating successful completion.

Replacement

CAUTION
The Restore function also provides easy and secure Single Device Replacement:
1. Remove the device to be replaced.
2. Connect the new device (make sure the new device has been previously set to fac-
3. Run the Restore procedure by selecting either Single Reader Restore (from file on
NOTE
PC); or Restore from external storage device.
For ID-NET network Restore, select the Internal Network replacement
selection.
The replacement device must be the exact same model as the device it is
replacing.
tory default).
PC) or Restore from external storage device item (see: Restore procedure).
In case of Backup or Restore operation failures, error messages will be
displayed in the Monitor Diagnostic page.
BACKUP AND RESTORE THROUGH DL.CODE
PRODUCT REFERENCE GUIDE
137