Table of Contents
Advertisement
7800 and 8200 Series Mortise Lock
Used with Sectional Trim and V Series Indicators
Installation Instructions
5
Installation (cont.)
d
Install Levers
1. Slide outside lever and rose assembly through
door and lock body, and hold. (Figure 8)
2. Slide inside spindle into lock body hub.
3. Slide adapter and plate assembly over spindle.
4. Secure with two (2) #8-32 x 5/8" screws.
5. Install inside rose onto adapter plate.
6. Install inside lever on adapter plate.
Secure with set screw.
e
Install Indicator Mounting Plate
1. Screw indicator mounting plate to door with
four (4) #6 x 3/8" sheet metal screws. (Figure 9)
2. If indicators are being used on both sides of
door, repeat step 1 for opposite side.
f
Install Indicator Assembly
1. Verify lock is in unlocked state
(turn outside lever to confirm).
2. Verify indicator is in
vacant/unlocked position.
3. Assemble indicator assembly
onto mounting plate. (Figure 10)
4. Secure indicator assembly to
door with two (2) machine
screws.
• Use #8-32 x 5/8" screw for top
• Use #8-32 x 3/8" screw for
5. If indicators are being used on
both sides of door, repeat steps 1
through 3 for opposite side.
Note:
Torx security screws recommended.
1-800-727-5477 • www.sargentlock.com
Copyright© 2019, 2020 SARGENT Manufacturing Company. All rights reserved. Reproduction in whole
or in part without the express written permission of SARGENT Manufacturing Company is prohibited.
bottom
Inside Lever
Set screw
Inside of door
Adapter
Plate
Rose
#8-32 x
5/8" screws
Spindle
Figure 8
Figure 9
Figure 10
5
RH door
shown
Outside of door
Outside
lever & Rose
Assembly
Mounting
Plate
#6 x 3/8"
screws
Indicator
Assembly
#8-32 x
5/8" screw
#8-32 x
3/8" screw
A8257C 03/20
Advertisement
Table of Contents
