Advertisement
Wing Fold Cylinder Installation
NOTE
Be sure the Hydraulic Cylinder ports are positioned
properly.
1. Check to make sure that the Center Frame Ball Joints
are free to rotate.
2. Apply anti-seize to Frame Ball Joints.
FRONT
F-1108-0121
TABLE OF CONTENTS
Hydraulic Cylinder, 4-1/2 x 36 (WFP 31-37)
Hydraulic Cylinder, 4 x 36 (WFP 23-29)
Ball Joints
location
Hydraulic Cylinder, 4-1/2 x 36 (WFP 31-37)
Hydraulic Cylinder, 4 x 36 (WFP 23-29)
Ports rear facing
Figure 2-10: Wing Fold Cylinder Installation
3. RH Cylinder ports are front facing and LH Cylinder
ports are rear facing. See Figure 2-10. Attach base
end of the 4 x 36 Hydraulic Cylinder (WFP23-29) or
4-1/2 x 36 Hydraulic Cylinder (WFP31-37) to the
Center Frame Ball Joints with the vendor supplied
hardware.
4. Block Cylinder Rod ends up from the frame to allow
for rod movement when purging the Hydraulic Circuit.
Ports front facing
2-13
Advertisement
