Advertisement
Transport Axle Linkage
Installation
NOTE
Linkage must be free to rotate after assembly
IMPORTANT
Clevis Pin Transport Lock must be removed when
lowering machine.
1. Assemble the Toggle Link Weldment to the Transport
Axle Assembly with 1 x 6-3/4 Pin. Secure with 3/8 x 2
Roll Pins. See Figure 2-2.
2. Place 1-1/16 x 3-1/2 Spacer between Transport Axle
Assembly Lugs. Secure with 5/8-11 x 6 Bolt and
Flange Locknut.
3. Place the Toggle Link w/Tap on the left side and the
Toggle Link on the right side of the Frame Center
Tube. Align the Toggle Links with the Frame Center
Tube Hole with spring bushing and insert 1" Pin
w/Keeper from left to right. Place 1" Flat Washer on
the end of the Pin. Secure with 3/8 x 2 Roll Pin.
4. Place the 1-3/8 x 1-1/16 Spacer between the
Hydraulic Cylinder Rod Clevis ears. Place a 1 x 2 x
1/4 Washer on each side of the Cylinder Rod Clevis.
Align Toggle Links with Cylinder Clevis and insert 1"
Pin W/Keeper from left to right. Place 1" Flat Washer
on the end of the Pin. Secure with 3/8 x 2 Roll Pin.
5. Place a 1 x 2 x 1/4 Washer on each side of the Toggle
Link Weldment. Align Toggle Links with the Toggle
Link Weldment and insert 1" Pin w/Keeper from left to
right. Place 1" Flat Washer on the end of the Pin.
Secure with 3/8 x 2 Roll Pin.
6. To prevent 1" Pins w/Keeper from rotating, secure
with 5/16-18 x 3/4 Bolts.
7. Insert 1/2 x 6 Clevis Pin into the Toggle Link, under
the Toggle Link Weldment and through the Toggle
Link w/Tap. Secure with Hair Pin Cotter. Clevis Pin is
the Transport Lock.
2-4
TABLE OF CONTENTS
F-1108-0121
Advertisement
