C Configuration Dbs - Siemens SIMATIC C7-613 Manual

Error Code
(W#16#...)
8223
8224
8400
840 x
8406
84xy
B-4
Cause
The DB for backing up the event
buffer on the MMC that is
specified in the "EVENT_DB"
parameter does not have the
"unlinked" attribute.
This check is performed only
after a backup job is initiated.
The DB for backing up the event
buffer on the MMC that is
specified in the "EVENT_DB"
parameter is write-protected.
This check is performed only
after a backup job is initiated.
The language selection
"SetLang" specified in the
configuration DB ("CONFIG") has
the value "0".
The language selection "SetLang
= x" specified in the configuration
DB ("CONFIG") is not available.
The language selection
"SetLang" specified in the
configuration DB ("CONFIG") has
a value > 5.
Parameter assignment is faulty in
DB y of language x.
Remedy
Check to determine whether the
"unlinked" attribute has been selected for
the specified DB. To select the "unlinked"
attribute, refer to the STEP 7 Online
Help.
Remove the write protection from the
specified DB. For information on
removing the write protection, please
refer to the STEP 7 Online Help.
Use the configuration interface to set the
language with which the C7-613 boots
up after restarting.
Use the configuration interface to set the
language with which the C7-613 boots
up after restarting.
Use the configuration interface to set the
language with which the C7-613 boots
up after restarting.
The values x and y mean:
•
x = Language index (1 to 5)
•
y = DB of the language (0 up to a
maximum of 5).
– 0 = Configuration DB
("CONFIG")
– 1 = First DB for process screens
("SCREEN")
The byte address within the DB at which
the error occurred is specified in the
parameter "ADDINFO" (hexadecimal
form).
Information on the DB structure is
contained in Appendix C.1 to C.5.
The parameter assignment is described
in Section 4.3.
C7-613 Control System
A5E00138934-03