Siemens SIMATIC C7-613 Manual page 162

Error information of the "HMI API" FB
Error Code
(W#16#...)
7000
7001
7130
8001
8002
8100
8101
B-2
Cause
Integrated HMI module of C7-613
is being initialized.
Parameter assignment for the
integrated HMI module of the
C7-613 is in progress.
The job compartment is occupied
at the moment.
An error occurred while reading a
data record (SFC 59).
An error occurred while writing a
data record (SFC 58).
Job number in the job
compartment is invalid or not
permissible.
Parameter 1 ("JOB_PAR1") of the
job compartment has an invalid
value for this job.
Remedy
This is a status message that provides
information about the function that is
currently being performed. The
integrated HMI module of the C7-613 is
undergoing a cold restart. No additional
action is required.
The integrated HMI module of the
C7-613 can also be initialized during
operation, if an internal error occurs in
the integrated HMI module or during
basic HMI functions.
HMI functions are not possible during
initialization. Outputting of pending
messages is delayed.
The DBs with the configuration data are
being loaded from the MMC to the
internal memory of the integrated HMI
module. This always occurs following a
power ON or general reset, or when the
"Reload application" or "Swap
languages" system function is applied.
Wait until the parameter assignment is
completed.
The integrated HMI module of the
C7-613 can also be configured during
operation, if an internal error occurs in
the integrated HMI module or during
basic HMI functions.
HMI functions are not possible during
parameter assignment. Incoming
messages are delayed.
The job that was initiated using the
"JOB_ID" parameter is not yet finished.
This job can be an internal job or one
that you initiated. Wait until the "JOB_ID"
has the value "0", and repeat the job
request before executing a new job.
The SFC 59 RETVAL is displayed using
the "ADDINFO" parameter. Additional
information on the SFC RETVAL can be
obtained in the STEP 7 Online Help.
The SFC 58 RETVAL is displayed using
the "ADDINFO" parameter. Additional
information on the SFC RETVAL can be
obtained in the STEP 7 Online Help.
Correct the job number in the "JOB_ID"
parameter. Valid values can be found in
the description of the controller tasks
(refer to Section 4.5.3).
Valid values for this job can be found in
the description of the controller tasks
(refer to Section 4.5.3).
C7-613 Control System
A5E00138934-03