Kostal PIKO 36 EPC Operating Manual page 9

General information
1 1 2 3
Exclusion of liability
Any use that differs from that described in Ch. 1.1 or
goes beyond the stated intended purpose, is considered
inappropriate. The manufacturer accepts no liability for
any damage resulting from this. Modifications to the
inverter are prohibited. The inverter may only be used
if it is safe to operate and is in a technically perfect
condition. Any instance of misuse will result in the
termination of the warranty, guarantee and general
liability of the manufacturer.
Only a qualified electrician may open the device.
The inverter must be installed by a trained electrician
(according to DIN VDE 1000-10 or BGV A3 accident
prevention regulations) who is responsible for observing
the applicable standards and regulations.
Work that could affect the electrical power system of
the relevant energy supply company at the site of the
solar power feed-in, may only be carried out by qualified
electricians expressly authorised (licensed) by the energy
supply company. This includes changes to the factory-
preset parameters. The installer must always observe the
regulations of the energy supply company.
Factory settings may only be changed by qualified
electrical installers or persons with at least comparable
or higher technical qualifications, e.g. foremen,
technicians or engineers. When doing so, all
requirements are to be observed.
© 2017 KOSTAL Solar Electric GmbH
4 5 6 7 8 9 10 11
IMPORTANT
INFORMATION
The inverter may only be installed,
maintained and repaired by a
trained and qualified electrician.
The electrician is responsible
for ensuring that the applicable
standards and regulations are
observed and implemented. Work
that could affect the electrical
power system of the relevant
energy supply company at the site
of the solar power feed-in, may
only be carried out by qualified
electricians expressly authorised
(licensed) by the energy supply
company.
This includes changes to the
factory-preset parameters.
9