Kostal PIKO 36 EPC Operating Manual page 115

Maintenance
1 2 3
Clean fan and housing opening with a soft brush.
6.
Pay attention to the following when installing:
7.
- The cable must point into the housing.
- The cable is secured in the device with the cable
guides.
- The cable of the fan must not be crushed.
- The fan must be correctly installed in the fan
frame (air flow direction).
Fig. 61: Fan installation
Reconnect the fan cable and insert the fan into the
8.
housing. When switching on for the first time, check
whether the air from the fan is drawn inwards.
Start up the inverter
9.
© 2017 KOSTAL Solar Electric GmbH
4 5 6 7
Fig. 61
Ch. 4.1
8 8 9 10 11
IMPORTANT
INFORMATION
When installing the fan ensure that
the cables are laid and refastened
so that they do not run into the fan.
If this is not done, the fan may fail
or noise may result.
Fasten fan cables with the cable
guides intended for this purpose
inside the housing.
115