Honda CBR1000F Manual page 81

Fuel System
NOTE
• No.3 carburetor is the base carburetor.
• Before tightening the carburetor connecting bolt/nut, check that not clearance between the each carburetor joints.
• Tighten the each connecting bolts/nuts gradually and alternately, be sure the bolt thread projections are equal
height. Hold the nut and tighten the other side nut.
Requisite Service
• Carburetor disassembly (page 5-8)
• Carburetor installation (page 5-4) • Carburetor synchronization (page 3-8)
Procedure O'ty
Remarks
Assemble No.3 carb. with No.4 carb.
(1)
Dowel pin (5mm bolt side)
1
(2)
Dowel pin (6mm bolt side) 1
(3)
Fuel joint pipe (3-way joint)/O-ring 1/2
Always replace the O-rings with new ones.
(4)
Air vent joint pipe/O-ring
1/2
(5)
Air joint rubber pipe 1
(6)
Thrust spring 1
(7)
No.4 carburetor synchronization spring 1
Assemble No.1 carb. with No.2 carb.
(8)
Dowel pin (5mm bolt side) 1
(9)
Dowel pin (6mm bolt side) 1
(10)
Fuel joint pipe (3-way joint)/O-ring 1/2 Always replace the O-rings with new ones.
( 11)
Air vent joint pipe/O-ring 1/2
(12) Air joint rubber pipe 1
(13)
Thrust spring 1
(14)
No.1 carburetor synchronization spring 1
Assemble No.3/4 carb. with No.1 /2 carb.
(15) Distance collared dowel pin(5mm bolt side) 1
(16)
Dowel pin (6mm bolt side) 1
(17) Air joint pipe (3-way joint)/O-ring
1/2 Always replace the O-rings with new ones.
(18)
No.2 carburetor synchronization spring 1
(19)
Starting enrichment valve cable holder 1
(20) Carburetor connecting nut/bolt, 5mm
2/1J
- CAUTION
(21)
Carburetor connecting nut/bolt, 6mm
2/1 • Tighten each nuts gradually and alternately with the
above procedure. Do not over tighten the nuts.
(22)
Plastic collar
2
(23)
Thrust spring
1
(24)
Starting enrichment valve arm
1
(25)
Plastic washer
2
(26) Starting enrichment valve arm screw 2
(27) Fuel tube/joint 1
5-13