Honda CBR1000F Manual page 238

17. Lights/Meters/Switches
Service Information
System Location
Bulb Replacement
Headlight Removal/Installation
Ignition Switch Removal/Installation
Service Information
17-1
17-2
17-3
17-5
17-6
Combination Meter Removal/
17-7
Installation
Combination Meter Disassembly/
17-8
Assembly
Tachometer Inspection
17-10
Side Stand Switch Removal/Installation
17-10
• A halogen headlight bulb becomes very hot while the headlight is ON , and remain hot for a while after it is turned
OFF. Be sure to let it cool down before servicing.
• Use a flame and heated water/coolant mixture for the thermo sensor inspection. Keep all flammable materials away
from the burner. Wear protective clothing, gloves and eye protection.
• Note the following when replacing the halogen headlight bulb.
- Wear clean gloves while replacing the bulb. Do not put finger prints on the headlight bulb, as they may create hot spots
on the bulb and cause it to break.
- If you touch the bulb with your bare hands, clean it cloth moistened with alcohol to prevent its early failure.
- Be sure to install the dust cover after replacing the bulb.
• All plastic connectors have locking tabs that must be released before disconnecting, and must be aligned when
reconnecting.
• Always turn off the ignition switch before disconnecting any electrical component.
• A continuity test can be made with switches installed on the motorcycle.
• Check the battery condition before performing any inspection that requires proper battery voltage.
• For the following component locations see 17-2 of this manual (System Location); for inspections refer to the applicable
pages.
Component
Inspection method
Remarks
Front brake switch Section 25 of the Common Service Manual
Horn
Section 25 of the Common Service Manual
Handlebar switch
Check for continuity on the continuity chart
Ignition switch
of the Wiring Diagram, page 18-1
Neutral switch
Section 25 of the Common Service Manual
Torque : 12 N • m (1.2 kg-m, 9, ft-lb)
Oil pressure switch/ Section 25 of the Common Service Manual
Oil pressure check: Section 4 of the
warning light
Common Service Manual
Oil pressure switch torque :
12 N • m (1.2 kg-m, 9, ft-lb)
Apply sealant to the threads.
Rear brake switch
Section 25 of the Common Service Manual
Turn signal lights Section 25 of the Common Service Manual
DJ
17-t