Honda CBR1000F Manual page 115

Clutch/Gearshift Linkage
Clutch Master Cylinder Removal/Installation
(7)
(2).,
/
(1)
0
35 (3.5, 25)
(3)
(4)
CAUTION
• Avoid spilling fluid on painted, plastic,or rubber parts. Place a rag over these parts whenever the system is serviced.
• When removing the oil bolt, cover the end of the clutch hose to prevent contamination.
• Do not allow the foreign material to enter the system.
NOTE
• Use DOT 4 brake fluid from a sealed container.
Requisite Service
• Clutch fluid draining/refilling
• Clutch system air bleading
Procedure
O'ty Remarks
Removal Order
Installation is in the reverse order of removal.
( 1) Clutch oil bolt
1
(2)
Sealing washer 2
(3) Clutch hose eyelet joint 1
At installation, press the eyelet joint against the stopper while
tightening the oil bolt.
(4) Clutch switch connector
2
(5)
Clutch master cylinder holder bolt
2 At installation, tighten the upper bolt first, then the lower bolt.
(6)
Clutch master cylinder holder
1 At installation, install the holder with its "UP" mark facing up.
(7)
Clutch master cylinder
1
At installation, align the mating surface with the punch mark
on the handlebar.
9-4