Honda CBR1000F Manual page 203

Brake System
Proportional Control Valve Removal/Installation
(4)
(5)
CAUTION
• Avoid spilling brake fluid on painted, plastic, or rubber parts. Place a rag over these parts whenever the system is
serviced.
• When removing the oil bolt, cover the end of the brake hose to prevent contamination.
• Do not disassemble the proportional control valve.
Requisite Service
• Seal cowl removal/installation (page 2-4)
• Brake system air bleeding (page 13-25)
Procedure
Q'ty
Remarks
Removal Order
Installation is in the reverse order of removal.
(1)
Oil bolt
2 Hold the proportional control valve using a open end
wrench, then loosen or tightening the bolts.
(2)
Sealing washer
4
(3)
Brake hose eyelet joint
2
(4) Proportional control valve assembly
1
(5)
Rubber suspension 2
13-24