Honda CBR1000F Manual page 127

Crankshaft/Transmission
NOTE
• Replace the weight, shaft and needle bearings as a set.
• After installation, adjust the balancer backlash (page 10-4).
Requisite Service
• Oil pan removal/installation (page 4-4)
Procedure
Q'ty
Remarks
Removal Order Installation is in the reverse order of removal.
(1)
Balancer shaft holder pinch bolt 1
(2)
Balancer shaft holder bolt 1
(3)
Balancer shaft lock bolt
1
(4)
Balancer shaft holder 1
(5)
Balancer shaft 1 NOTE
• At installation, check for align the index mark on the
weight with the punch mark on the gear (page 10-5) and
install the the balancer shaft with the I.D. code number
facing forward with the punch mark on the balancer
gear facing to oil pan.
(6)
O-ring
1
(7)
Balancer weight assembly 1
NOTE
• The balancer assembly will only come out from one
particular position. Rotate it until it comes out easily; do
not force it out.
• At installation,rotate the crankshaft counterclockwise
and align the index mark on the pulse generator rotor
with "T" mark on the crankcase.
• At installation, align the index mark on the weight with
index mark on the crankcase.
10-3