Honda CBR1000F Manual page 206

Fill the reservoir up to the "UPPER" level.
Specified brake fluid: DOT 4 brake fluid
Install the following:
- Diaphragm
- Set plate
- Reservoir cover
-Screws
Turn the adjuster, adjust the brake lever position.
Pedal Brake Line Air Bleeding
NOTE
• For correct air bleeding, comprehend the pedal brake
line referring to the Technical Feature in section 19.
• Make sure the secondary master cylinder orifice bolt is
loosened fully until it seats on the snap ring.
• Bleed the air from the pedal brake line in the sequence
as follow:
1. Right front brake caliper center bleeder
2. Left front brake caliper center bleeder
3. Rear brake caliper center bleeder
4. Rear brake caliper outer bleeder
Remove the right side cover (page 2-3).
Remove the bolt and intake air duct.
Remove the rear master cylinder reservoir tank mounting
bolt.
Remove the following:
- Reservoir cap
- Set plate
-Diaphragm
Fill the reservoir DOT 4 brake fluid.
Pump the brake pedal while filling the brake fluid and feed
fluid into the master cylinder.
Brake System
(2) AIR DUCT
(1) BOLT
(1) BOLT
(1) RESERVOIR
/
~
; '0
~
(2) BRAKE PEDAL
13-27