Honda CBR1000F Manual page 18

General Information
Torque Values
~Standard
Fasteners Type
Torque
Fasteners Type
Torque
N • m (kg-m, ft-lb) N • m (kg-m, ft-lb)
5 mm hex bolt and nut
5 (0.5, 3.6) 5 mm screw 4 (0.4, 2.9)
6 mm hex bolt and nut
10 (1.0, 7) 6 mm screw 9 (0.9, 6.5)
8 mm hex bolt and nut
22 (2.2, 16) 6 mm flange bolt (8 mm head)
9 (0.9, 6.5)
10 mm hex bolt and nut
35 (3.5, 25) 6 mm flange bolt (10 mm head) 12 (1.2, 9)
12 mm hex bolt and nut
55 (5.5, 40)
and nut
8 mm flange bolt and nut
27 (2.7, 20)
10 mm flange bolt and nut 40 (4.0, 29)
Torque specifications listed below are for important fasteners. Others should be tightened to standard torque values listed
above.
Notes: 1. Apply sealant to the threads.
2. Apply a locking agent to the threads.
3. Apply molybdenum disulfide oil to the threads and flange surface.
4. Stake.
5. Apply oil to the threads and flange surface.
6. Apply clean engine oil to the O-ring.
7. Apply grease to the threads and flange surface.
8. UBS bolt.
9. U-nut.
10. ALOC bolt.
-
Eng·n
I
e
Item
O'ty
Thread
Torque
Remarks
dia. (mm)
N • m (kg-m, ft-lb)
Maintenance:
Timing hole cap
1
45
18 (1.8, 13)
Note 7
Spark plug
4 12 15 (1.5, 11)
Lubrication System:
Oil filter boss 1 20 18 (1.8, 13)
Note 2
Oil filter cartridge
1
20 10 (1.0, 7)
Note 5
Oil drain plug
1
14 30 (3.0, 22)
Oil pass plate
3 6 12 (1.2, 9)
Note 2
Oil pipe C special bolt 2 6 12 (1.2, 9)
Note 2
Oil pump driven sprocket bolt
1 6 15 (1.5, 11)
Note 2
Oil pump assembly flange bolt
3 6 13 (1.3, 9)
Oil pressure switch
1 PT 1/8 12 (1.2, 9)
Note 1
Oil pressure switch connector bolt
1
4
2.2 (0.22, 1.6)
Fuel System:
Carburetor connecting nut, 6 mm
2 6 10 (1.0, 7)
5mm
2 5 5.2 (0.52, 3.8)
Cooling System:
Water pump flange bolt 2 6 13 (1.3, 9)
Water pipe D flange bolt
2
6 13 (1.3, 9)
1-14