Honda CBR1000F Manual page 151

Front Wheel/Suspension/Steering
• Contaminants in the system may cause a reduction or loss of braking ability.
CAUTION
• Spilling brake fluid will damage painted, plastic, or rubber parts.
NOTE
• Using wires, hang the front brake master cylinder at least as high as the position it was originally installed at to
prevent air from getting into the master cylinder. Do not twist the brake hose.
• Route the cables and wire harnesses properly.
Requi•ite Service
• Throttle grip free play adjustment (Section 2 of the Common Service Manual)
Procedure
Removal Order
(1) Brake switch connector
(2) Master cylinder holder bolt
(3) Master cylinder holder
(4)
Master cylinder assembly
(5) Handlebar weight
(6)
Right handle switch screw
(7)
Right handle switch housing
(8) Throttle cable
(9)
Throttle pipe
(10)
Stop ring
(11)
Right handlebar pinch flange bolt
(12) Right handlebar
Q'ty
2
2
1
1
1
2
1
2
1
1
1
1
Remarks
Installation is in the reverse order of removal.
At installation, tighten the upper bolt first.
• At installation, align the mating surface of the master
cylinder and holder with the punch mark on the
handlebar.
• Install the holder with its "UP" mark facing up.
At installation, align the locating pin the engine stop
switch with the hole on the handlebar.
At installation, align the stopper on the handlebar with
the groove in the top bridge.
11-3