Honda CBR1000F Manual page 137

Crankshaft/Transmission
NOTE
• Apply molybdenum oil to the shifter gear grooves.
• Always install the thrust washers and snap rings with the chamfered(rolled) edge facing away from the thrust
load.
• After installing a snap ring, slightly open the ring and rotate it in its groove to be sure it is fully seated.
• Do not use worn snap rings which could easily spin in the groove. They may be too loose to properly seat in the
groove.
• Align the gap in the snap ring with the groove of spline.
Requisite Service
• Transmission removal/installation (page 10-8)
Procedure O'ty Remarks
Countershaft Disassembly Order
Assembly is in the reverse order of disassembly.
(1) Needle bearing
1
(2)
Washer 1
(3) C1 gear (33T)
1
(4)
Needle bearing 1
(5)
Washer
1
(6)
C6 gear (23T) 1
(7)
Snap ring 1
(8)
Spline washer
1
(9)
C4 gear (26T) 1
(10)
C4 gear spline bushing 1
(11)
lock plate 1 At installation, align the tabs on the plate with the cut outs
of the washer.
(12) Lock washer 1
(13)
C3 gear (28T) 1
(14)
C3 gear spline bushing 1
(15)
Spline washer 1
(16)
Snap ring 1
(17)
C5 gear (27T) 1
(18)
Snap ring
1
(19)
Spline washer
1
(20)
C2 gear (31T) 1
(21) C2 gear bushing 1
(22) Countershaft 1
10-13