Honda CBR1000F Manual page 172

Rear Wheel/Suspension
• A contaminated brake disc or pad reduces stopping power. Discard contaminated pads and clean a contaminated
disc with a high quality brake degreasing agent.
NOTE
• Replace the wheel bearings in pairs.
• Do not add more than 60 grams of balance weight to the wheel.
Requisite Service
• Rear wheel removal/installation (page 12-2)
Procedure
O'ty
Remarks
Disassembly Order
Assembly is in the reverse order of disassembly.
(1)
Brake disc mounting bolt
6
(2)
Brake disc 1
At installation, install the disc with its "¢DRIVE" mark
facing out.
(3) Driven flange assembly 1
Driven Flange Disassembly Order
(a)
Driven sprocket nut 5
Temporarily install the driven flange into the wheel hub,
then remove the nuts.
(b)
Driven sprocket
1
(cl
Rear axle sleeve
1
(d)
Dust seal
1
(e)
Driven flange bearing (62/22)
1
(4)
Damper rubber
5
(5)
0-ring, 69 x 2 mm
1
(6)
Right dust seal
1
(7) Left wheel bearing (6304 UU)
1
(8)
Distance collar
1
(9) Right wheel bearing (6304 UU)
1 NOTE
• Drive in the right side bearing first, then the left side
bearing.
12-5