Manual Torque Boost - Increasing Torque Boost At Low Speeds - Toshiba TOSVERT VF-nC3E Instruction Manual

7) The maximum length of wires between the inverter and motor is 30 meters. If the wires are longer than 30
meters, set standard auto-tuning with the wires connected to improve low-speed torque during sensorless
vector control.
However the effects of voltage drop cause motor-generated torque in the vicinity of rated frequency to be
somewhat lower.
8) When a reactor is connected between the inverter and a motor, the motor's generated torque may fall.
Setting auto-tuning may also cause a trip () rendering sensorless vector control unusable.
5.12 Manual torque boost - increasing torque boost at low
speeds
 : Torque boost 1
 Function
If torque is inadequate at low speeds, increase torque by raising the torque boost rate with this
parameter.
Base frequency voltage
[Parameter setting]
Title

Torque boost value 1
★ Valid when  is set to 0 (V/F constant) or 1 (square reduction)
Note 1: The optimum value is programmed for each inverter capacity. Be careful not to increase the torque boost
rate too much because it could cause an overcurrent trip at startup.


Function
0.0 - 30.0 (%)
E-23
Output frequency (Hz)
Base frequency 
Adjustment range
(Refer to section 10.4)
E6582233
5
Default setting
According to model