Table of Contents
Advertisement
Installing the Projector
Function
Rename Memory
Reset Memory
a
If the mark on the left of the memory name is turned blue, it
means the memory has already been registered. When you
select a registered memory, a message is displayed asking you to
confirm that you want to overwrite the memory. If you select
Yes, the previous settings are deleted and the current settings
are registered.
ID Settings
When an ID is set for the projector and the remote control, you can use
the remote control to operate only the projector with a matching ID. This
is very useful when managing multiple projectors. You can set up to 30
IDs.
Explanation
Changes the memory name. Select the memory
name you want to change, and then press the [
button. Enter the memory name using the soft
keyboard.
s "Soft keyboard operations"
p.153
When you have finished, move the cursor over
Finish, and then press the [
] button.
Resets the name and settings of a saved memory.
a
Operation using the remote control is possible only for projectors
that are within the operating range of the remote control.
]
s "Remote control operating range"
IDs are ignored when the projector ID is set to Off or the remote
control ID is set to 0.
If you use Epson Web Control, you can operate a specific projector
from a mobile device.
s "Changing Settings Using a Web Browser (Epson Web Control)"
p.230
Set the projector ID
a
Press the [Menu] button while projecting.
"Configuration Menu Operations"
s
b
Select Multi-Projection from Extended.
c
Select Projector ID, and then press the [
d
Press the [ ][ ] buttons to select an ID number.
e
Select Set, and then press the [
f
Press the [Menu] button to close the Configuration menu.
43
p.27
p.137
] button.
] button.
Advertisement
Table of Contents
