Epson EB-L30002U User Manual page 180

Reading the Indicators
Indicator
Power Status Laser
Blue -
Status Status
Flashing
varies varies
Status Status Status
varies varies varies
Orange -
Status Status
Flashing
varies varies
Cause
Temp Filter
Low Air Flow
Orange -
Status
On
varies
Air Filter Notice
Orange -
Status
Flashing
varies
Constant Bright‐
ness End
Status Status
varies varies
Remedy or Status
This is not an error. However, projection stops automatically if the airflow falls
any further.
The message "The air filter is clogged. Clean or replace the air filter." is displayed.
Check the following two points.
 Check that the air filter and air exhaust vent are clear, and that the projector is
not positioned against a wall.
 If the air filter is clogged, turn off the power, remove the power cord from the
electrical outlet, and then clean or replace them.
s "Cleaning the Air Filter and Air Intake Vent"
s "Replacing the Air Filter" p.221
If the error continues after checking the points above, stop using the projector,
remove the power plug from the electrical outlet, and contact your local dealer or
the nearest address provided in the Epson Projector Contact List.
Epson Projector Contact List
s
"Time to clean the air filter. Clean or replace the air filter." is displayed.
Turn off the projector's power, unplug the power cord from the electrical outlet,
and then clean the air filter.
s "Cleaning the Air Filter and Air Intake Vent"
The indicators or messages regarding air filter notice are displayed only when
Air Filter Notice is set to On in the Configuration menu.
s Extended - Display - Air Filter Notice
Ends the Constant Brightness mode in Brightness Settings.
s "Setting the Brightness" p.75
Airflow Decline
p.216
Clean Filter
p.216
p.147
ConstBRT Expired
180
LCD Display