Table of Contents
Advertisement
List of Functions
Submenu
IP Address Dis‐
To prevent the IP address from being displayed on the LAN
play
Standby screen, set this to Off.
Perform settings to use the IPv6 protocols.
IPv6 Settings
a
IPv6: Set this to On when using IPv6 protocols. Make sure one
link local address is set when using IPv6. This is composed of the
interface ID created from fe80:: and the projector's MAC address.
Auto Configuration: Set this to On to automatically acquire an
IPv6 address from RA (Router Advertisement). The address is
composed as shown below.
Stateless Address (0 to 6): Created automatically by combining
the prefix acquired from the RA (Router Advertisement) and
the interface ID created from the projector's MAC address.
Stateful Address (0 to 1): Created automatically from the
DHCP server using DHCPv6.
Use Temporary Address: Set this to On to temporarily validate
the IPv6 address (0 to 1) when Auto Configuration is On.
Notifications menu
When this is set, you receive an email notification if a problem or warning
occurs in the projector.
Function
The following functions support IPv6 proto‐
cols.
- Epson Web Control
- PJLink
When setting the IPv6 address manually,
make settings in Advanced from Epson Web
Control.
s "Changing Settings Using a Web Browser
(Epson Web Control)"
p.230
"Reading error notification mail"
s
Submenu
Set to On to send an email to the preset addresses when a problem
Mail Notification
or warning occurs with a projector.
You can input the IP Address for the SMTP server for the
SMTP Server
projector.
You can enter a number from 0 to 255 in each field of the address.
However, the following IP addresses cannot be used.
127.x.x.x, 224.0.0.0 to 255.255.255.255 (where x is a number from
0 to 255)
You can input the port number for the SMTP server. The default
Port Number
value is 25. You can input numbers between 1 to 65535.
Enter the email address of the sender. You can enter up to 64
From
single-byte alphanumeric characters. You can enter up to 32
characters on the Configuration menu. When entering more
than 32 characters, use your Web browser to enter the text.
( " ( ) , : ; < > [ \ ] and spaces cannot be used.)
s "Changing Settings Using a Web Browser (Epson Web
Control)"
p.230
159
p.238
Function
Advertisement
Table of Contents
