Table of Contents
Advertisement
Problem Solving
Problems Relating to Images
No images appear
Check
Is the main power switch set to Off?
Did you press the [
] button on the remote control or control
panel?
Are the indicators switched off?
Is Shutter active?
Are the Configuration menu settings correct?
Is the image to be projected completely black?
(Only when projecting computer images)
Is Windows Media Center displayed in full screen?
(Only during network connection)
Is an application using the Windows DirectX function displayed?
(Only during network connection)
Are you using any other image display equipment with the
projector?
Is the signal from the 3G/HD/SD SDI port set correctly?
Is the EDID set correctly?
Turn on the main power switch to supply power to the projector.
Press the [
] button to turn on the power.
The power cord is not connected correctly or power is not being supplied.
Connect the projector's power cord correctly.
Check that your electrical outlet or power source is functioning correctly.
Press the [Shutter] button to release the Shutter function.
s "Hiding the Image Temporarily (Shutter)"
Reset all of the settings.
s Reset - Reset All Config
p.163
Some input images, such as screen savers, may be completely black.
When Windows Media Center is displayed at full screen, you cannot project using a network connection. Reduce the
screen size.
Applications using the Windows DirectX function may not display images correctly.
Other image display equipment may have a different resolution. Change the EDID setting on the Signal menu.
s Signal - Advanced - EDID
p.143
Check the SDI Settings from the Configuration menu.
s Extended - SDI Settings
p.147
Disconnect the cable for the image currently being projected from the projector, and then make EDID settings again.
s Signal - Advanced - EDID
p.143
Remedy
p.106
201
Advertisement
Table of Contents
