Adjusting The Horizontal Tilt (For Normal Installment); Id Settings; Set The Projector Id - Epson EB-G7905U User Manual

Installing the Projector
B
Retract the front foot.
a
The larger the angle of tilt, the harder it becomes to focus. Install the
projector so that it only needs to be tilted at a small angle.
Adjusting the Horizontal Tilt (for Normal
Installment)
Extend and retract the rear feet to adjust the projector's horizontal tilt.
A
Extend the rear foot.
B
Retract the rear foot.
Attention
The rear feet can be attached and removed. Note that the feet will detach if
they are extended more than 10 mm.

ID Settings

When an ID is set for the projector and the remote control, you can use
the remote control to operate only the projector with a matching ID. This
is very useful when managing multiple projectors. You can set up to 30
IDs.
a
• Operation using the remote control is possible only for projectors
that are within the operating range of the remote control.
s "Remote control operating range"
• When Remote Control Type is set to Simple in the configuration
menu, you cannot set the remote control ID.
s Extended - Operation - Advanced - Remote Control Type
p.142
• IDs are ignored when the projector ID is set to Off or the remote
control ID is set to 0.
• If you use Epson Web Control, you can operate a specific projector
from a mobile device.
s "Changing Settings Using a Web Browser (Epson Web Control)"
p.204

Set the projector ID

a
Press the [Menu] button while projecting.
"Using the Configuration Menu"
s
b
Select Multi-Projection from Extended.
c
Select Projector ID, and then press the [
d
Press the [ ][ ] buttons to select an ID number.
41
p.24
p.134
] button.