Installing Hkcu2005 (To Hdcu1000 With Hkcu-Hb10 Installed) - Sony HKCU-HB10 Maintenance Manual

1-3-2. Installing HKCU2005
(to HDCU1000 with HKCU-HB10
Installed)
Installing the HIF-57 board (option)
1. Remove the standard HIF-26 board of slot 2
and the blank panel of slot 3
(Refer to Section 1-3-1.).
n
Keep the removed blank panel.
2. Insert the HIF-57 board into slot 2 and the
standard HIF-26 board into slot 3, and secure
them with four screws.
m
. When another option board is mounted in
slot 3 or a subsequent slot, reinstall it
according to the output signal confi guration
required by the customer.
. For combination of option boards, refer to
"2-4. Option Board Installation Position."
. Be sure to install blank panels to open slots.
Installing the DRX-8 board (option)
1. Remove the front panel.
(Refer to Section 1-3-1.)
2. Remove the standard DRX-5 board from slot
2, set the switch 4 (MONI) to OFF, and then
insert the DRX-5 board into slot 3.
3. Set the switch S4 (MONI) on the standard
DRX-5 board in slot 1 to OFF.
(Refer to Section 1-2.)
4. Check that the switch S4 (MONI) on the
DRX-8 board is set to ON.
(Refer to Section 1-2.)
1-12 (E)
2 2
3 3
4 4
5 5
6 6
HIF-57board HIF-57board
(option) (option)
Standard HIF-26 board Standard HIF-26 board
Standard DRX-5 board Standard DRX-5 board
B3 x 5 B3 x 5
S4: OFF S4: ON S4: OFF S4: OFF S4: ON S4: OFF
1 1 2 2 3 4 5 6 3 4 5 6
Slot Slot
HKCU-HB10