Sony HKCU-HB10 Maintenance Manual page 14

16. Pull the SDI-85 board, SDI-86/86G board,
and CN-2674/2674G board out of the MB-
1071/1071A board in the arrow direction.
17. Connect the supplied harness (REMOTE) to
the connector CN5 on the ADO-10/10G
board.
. Serial number 15001 and Higher (UC)
. Serial number 420002 and Higher (CE)
18. Install all the boards that were removed in
step 16.
19. Connect the harness (REMOTE) to the con-
nector CN18 on the CN-2672GA board.
20. Connect the fl exible card wire, harness, and
power cable by reversing steps 6 to 9 and
arrange them as shown in the fi gure.
1-8 (E)
CN5 CN5
(ADO-10/10G board) (ADO-10/10G board)
MB-1071/ MB-1071/
1071A board 1071A board
CN1 CN1
CN-2718 board CN-2718 board
Harness (REMOTE) Harness (REMOTE)
Flexible card wire Flexible card wire
Harness Harness
(REMOTE) (REMOTE)
SDI-86/86G board SDI-86/86G board
CN-2674/2674G board CN-2674/2674G board
SDI-85 board SDI-85 board
Power cable Power cable
CN-2672GA board CN-2672GA board
Harness (CAMERA) Harness (CAMERA)
CN15 CN15
CN18 CN18
HKCU-HB10